Micromod MOD: 30MLTraining Manual - Manual (Page 182)

Training Manual
Sequence Lab
Figure 12 .4.
Blocks
4. Configure the I/O blocks:
• Digital Inputs/Outputs: Change the tag names and descriptions. Accept all other entries in
their default. The tag names and descriptions are as below:
• LSL - Level Switch LOW DIM
• LSH - Level Switch HIGH DIM
• Draining - Feed back from the drain valve DIM
• Drain - Output to Drain Valve DOM
• Charge - Output to Charge valve DOM
• Analog Inputs and Function blocks: Change the tag names and descriptions. For the RTI
block configure the quality limits as -5 to 105 Degrees Celsius.
• TE - Reactor Temperature sensor WRIM
• TI - Reactor Temperature RTI
5. Define locations for the I/O Modules on the board:
• Select Instrument - I/O Graphic - MOD30ML from the menu bar at the top. See next
figure:
12 - 4