Micromod MOD: 30MLTraining Manual - Manual (Page 245)

Training Manual
Piecewise Linearization Lab

The table can be used by the
linearization block for either piecewise
(X coordinates) or inverse piecewise (Y
coordinates) linearization. The
appropriate coordinates must ALWAYS
be in ascending order with no duplicates.
Up to 60 pairs may be entered. Blocks
can be cascaded if more pairs are
required.
11. Close the block by clicking OK.
D - CONFIGURE THE LINEARIZATION BLOCK
12. Double-click the LN block to open it.
13. Type FW LN in the Name field and type a Description such as:
Feedwater valve linearization
14. Use the pull-down menu to set the Linearization Type to
Piecewise
18 - 5