Micromod MOD: 30MLTraining Manual User Manual
Page 196
Advertising
Training Manual
Sequence Lab
Figure 12 .25.
SEQ Choose
Parameter - digital
• Select LevelLO from this dialog and then click on OK.
• Make the other connections in the same way. Use the following table:
Source Destination
LevelHI.R (DIM block)
StepMGR.LevelHI (SEQ)
TE.Modout (WRIM block)
TI.Modin (RTI block)
Draining.R (DIM block)
StepMGR.Draining
TI.R (TI block)
StepMGR.Temp
StepMGR.DrainV
Drain.Input (DOM block)
StepMGR.ChargeV
Charge.Input (DOM block)
After making the connections, your screen should look like the next figure:
12 - 18
Advertising
This manual is related to the following products: