Micromod MOD: 30MLTraining Manual - Manual (Page 92)

Training Manual
PID Loop Lab
Figure 6 .16.
Loop Block
• Close the Loop block by clicking on the OK button.
9. Configure the PID loop shown in Figure 6.17:
• Let us start doing this by adding the necessary algorithm blocks to the Loop
Compound on the workspace on the right frame. Add the following blocks to the
database:
• AIN – Built-in Analog Input
• VCI – Voltage or Current Input function block
• PID – PID algorithm block
• AOUT – Built-in Analog Output block
You can either select the specific category at the bottom of the Algorithms menu first and
then the blocks or you can select the category All to pick any block.
After you placed the above blocks in the database, the right frame on your configurator
screen should look something like the next figure.
6 - 12