Micromod MOD: 30MLTraining Manual - Manual (Page 188)

Training Manual
Sequence Lab
After adding all the inputs, the Inputs tab should look like the following figure:
Figure 12 .14.
SEQ Properties -
Inputs Tab
• Notice that these inputs are assumed to be local until we connect them external inputs and
are assigned initial values as shown in the figure below.
• The inputs can be in any order. To rearrange the entries, use the Move Up / Move Down
buttons.
8. Add Sequence Outputs:
• We need to add the outputs to the sequencer now. Click on the Outputs tab of the SEQ
Properties dialog box.
12 - 10