Micromod MOD: 30MLTraining Manual - Manual (Page 234)

Training Manual
Sequence Display Lab
Entry method: Enter required The operator must push an Enter key.
When “Enter required” is specified, ENT
will appear on Line 5 when the arrow key
is pressed.
Display state table: Start The name of the table we defined in the
State Table block.
Entry state table: Start The name of the table we defined in the
State Table block. This will be used when
the operator is required to press the ENT
key.

Note that Display and Entry state tables may be the same, or
they can be different, so that a different set of text is shown when
the operator pushes a key for entry. If Entry Method is set to
None, an Entry state table is not required.
16. Using the Add button, add the following formats:
Name Format Type Low
Limit High
Limit Entry Method Display state
table Entry state
table Eng units
StepL State None StepName
TempL Float1 0 100 None o
The Formats tab should look like this:
Write the display script:
A script is required because the information displayed on Line 6
comes from different sources depending on the sequence step
(the value of the input Step).
17. Click on the Scripts tab
18. Type the following script into the Scripts window. Be sure to
exactly follow the punctuation.
17 - 8