FEC AFC1500 - Manual (Page 10)

Never operate the equipment with wet hands.
Failure to observe this instruction may cause electric shock.
Keep fingers away from the
is turned ON or for a while after the equipment is turned OFF. These parts may become very
hot. Failure to observe this instruction may cause burns.
Use the equipment under the following conditions.
◆Ambient temperature: 0°C
◆Ambient humidity: 90% RH or lower
◆Atmosphere: Indoors (Avoid direct sunlight)
No
corrosive gases or flammable gases
No oil mist, dust, water, salt, iron powder
◆Avoid direct vibration or s
Failure to observe this instruction may cause
Confirm and adjust all parameters before operation
movement of the equipment.
Failure to observe this instruction may cause injury,
Never conduct extreme adjustments or setting changes that may cause instability of
Failure to observe this instruction may cause injury,
The equipment may restart suddenly
Always ensure that the start signal is OFF before resetting the equipment.
Failure to observe this instruction
Do not turn ON and OFF the equipment repeatedly.
Failure to observe this instruction
Do not use the equipment at torque higher than
Failure to observe this instruction may shorten
due to the high temperature caused by overload.
In case any abnormality occurs,
and restarting the equipment.
Failure to observe this instruction may cause injury.
Safety Precautions
Operation / Adjustment
Never operate the equipment with wet hands.
this instruction may cause electric shock.
Keep fingers away from the AXIS (SAN) Unit radiating fin and tool motors while the equipment
is turned ON or for a while after the equipment is turned OFF. These parts may become very
this instruction may cause burns.
Use the equipment under the following conditions.
0°C
～+45°C (Avoid freezing)
Ambient humidity: 90% RH or lower (Avoid moisture)
Indoors (Avoid direct sunlight)
corrosive gases or flammable gases
No oil mist, dust, water, salt, iron powder
Avoid direct vibration or shocks
this instruction may cause earth leakage and malfunction.
ll parameters before operation in order to prevent unexpected
movement of the equipment.
this instruction may cause injury, false operation and malfunction.
adjustments or setting changes that may cause instability of
this instruction may cause injury, false operation and malfunction.
The equipment may restart suddenly when the equipment is reset with the start signal ON.
Always ensure that the start signal is OFF before resetting the equipment.
instruction may cause injury.
Do not turn ON and OFF the equipment repeatedly.
instruction may cause malfunction.
equipment at torque higher than the maximum torque.
Failure to observe this instruction may shorten equipment life or cause malfunction
due to the high temperature caused by overload.
mality occurs, remove the cause and ensure safety before resetting
and restarting the equipment.
Failure to observe this instruction may cause injury.
Caution
Safety Precautions
/ Adjustment
tool motors while the equipment
is turned ON or for a while after the equipment is turned OFF. These parts may become very
in order to prevent unexpected
and malfunction.
adjustments or setting changes that may cause instability of operation.
and malfunction.
is reset with the start signal ON.
or cause malfunction
remove the cause and ensure safety before resetting
Caution