3 bank select table – FEC AFC1500 User Manual
Page 64
Chapter 4: System Setup and Wiring
Page 4-20
4.7.3 Bank Select Table
Bank Select inputs are used to “multiplex” the output signals allowing up to 32 signals from
only 8 physical outputs. By changing the input conditions of these two inputs, up to four
“Banks” may be selected, changing the definition of each output point.
BANK
#
BANK SELECT
INPUT
PLC / SAN UNIT BANK DATA
1
0
BANK DATA SIGNAL NAME
SIGNAL DESCRIPTION
1
OFF OFF
DATA 0
(SAN2 PIN 25)
(SAN3 PIN 31)
REJECT
Output when the fastening result is a REJECT. Indicates that the
spindle has failed the fastening limits. This output remains active
until the START signal or RESET signal is input.
DATA 1
(SAN2 PIN 24)
(SAN3 PIN 30)
ACCEPT
Output when the fastening result is a ACCEPT. Indicates that the
spindle is within the fastening limits. This output remains active until
the START signal or RESET signal is input.
DATA 2
(SAN2 PIN 23)
(SAN3 PIN 29)
ABNORMAL
Output when an Abnormal condition occurs, indicates that the
System has detected an internal fault, and can no longer proceed.
An Abnormal condition must be corrected before the System will re-
sume normal operation.
DATA 3
(SAN2 PIN 22)
(SAN3 PIN 28)
READY
Output when the system is in READY condition to operate, and in-
puts are enabled. This signal is inactive (off) when the BUSY out-
put is active (on).
DATA 4
(SAN2 PIN 21)
(SAN3 PIN 27)
BUSY
Output after a START signal is received, and active until the fas-
tening cycle is complete and the READY signal is output.
DATA 5
(SAN2 PIN 20)
(SAN3 PIN 26)
TORQUE HIGH
REJECT
Output when Fastening resulted in a Torque High Reject.
DATA 6
(SAN2 PIN 19)
(SAN3 PIN 25)
TORQUE LOW
REJECT
Output when Fastening resulted in a Torque Low Reject.
DATA 7
(SAN2 PIN 18)
(SAN3 PIN 24)
BYPASS
Output when the spindle is bypass either via PLC input or the
San Unit front panel switch.
DATA 8
(SAN3 PIN 34)
NOT USED
DATA 9
(SAN3 PIN 33)
NOT USED
DATA 10
(SAN3 PIN 32)
DATA
AVAILABLE
Output when the fastening result data is ready to report.
Turns off when the fastening data being reported.
DATA 7
(SAN3 PIN 22)
TRQ. RECV.
Output while the system is in torque recovery mode.