FEC AFC1500 - Manual (Page 136)

Chapter 7: System Operations
Page 7-22
7.2.6 STATUS display
Two types of non-Fastening Results STATUS can be displayed, either STOP or ABNORMAL.
1) When the STOP signal is activated:
The DATA display will indicate when the STOP signal has halted the SAN Unit as shown in
the figure.
2) When an ABNORMAL condition occurs the [PARM] display will show a flashing "A" char-
acter followed by a number that represents the Abnormal number code. The [D-NO] displays
a number that represents the SERVICE CODE NUMBER or SUB Code. (Refer to chapter 9)
The following example values are displayed during Fastening operations using Parameter No. 1
■ During Initial ■ During Freerun ■ During Slowdown ■ During Torque
Speed Speed Speed Speed
■ STEP 2 ■ STEP 2 ■ STEP 3 Stand by ■ STEP 3
Waiting Fastening Waiting Fastening
■Offset Check ■ Reverse 2 Revolutions ■ Reverse 3 Revolutions
Normal manual reverse (Reverse 1) operation is not displayed.