FEC AFC1500 User Manual
Page 125
AFC1500 Operations Manual
Chapter 7: System Operations (Rev. 6.1: 1/13)
Page 7-11
Data No.00 Torque Unit
All fastening parameters inside the spindle use the same torque unit.
0= Nm, 1=Kgm, 2=Kgcm, 3=Ftlbs, 4=Inlbs
Data No.01 NR Version / Parameter Copy
This shows the version of AXIS Unit software version and can be used to perform the fol-
lowing functions.
How to copy parameters individually
Enter the parameter Number of the copy source into the first two digits of [DATA] indicator, and the
parameter No. of the copy destination into the last two digits.
The parameter will be copied when normal parameter setting procedure is completed.
How to copy multiple parameters at once
Enter 99 into the first two digits of [DATA] indicator, and 16 into the last two digits. Perform normal
parameter setting procedures. Parameter 1 will be copied to parameter 2~16.
How to erase fastening results record
Enter 99 into the first two digits of [DATA] indicator, and 99 into the last two digits. Perform normal
parameter setting procedures. Fastening results records will be all erased.
Data No.02 Amplifier Version
Version of amplifier is displayed.
Data No.03 Function Version
This is used for special functions.
Setting: 1.03 = Multi assumes I/O 1.27= Stand-Alone PLC I/O 1.23=Dual Transducer Mode
Data No.04 External Gear Ratio
Standard setting: 1.000
Setting range: 0.300 ~ 3.000
Used to adjust the gear ratio when an external head is connected to the output of the tool assembly.
Data No.07 Angle Decimal Point
Firmware Version 5.09 or later
Setting 0000 or, 0002 : No Angle Decimal place (1) Ex. xxxx degrees
Setting 0001 or 0003 : One Decimal place (0.1) Ex. xxx.x degrees
Data No.20 Tool No.
Set the connected tool number from the appendix [Tool Type List] included in the end of this instruc-
tion manual.
Data No.30 Time Setup
Sets the Date / Time when a SAN3-DP1 or DP2 is used. (Requires a SAN3
– DPx to be installed)
System Parameters Parameter No. 00
SET
↑
↓
Source Destination
SET
Copy
* Cannot be changed
* Cannot be changed
* Cannot be changed