FEC AFC1500 - Manual (Page 123)

AFC1500 Operations Manual Chapter 7: System Operations (Rev. 6.1: 1/13)
Page 7-9
7.2.5 Parameter Data List
Item
Parameter No.
PARM
Data No.
D-NO
DATA Unit
System
00 00 Torque Unit [0:Nm]
00 01
NR Version / Parameter Copy
<*Cannot be changed>
00 02 Amplifier Version <*Cannot be changed>
00 03 Stand Alone or Multi Config. See 7.3.7
00 04 External Gear Ratio
00 07 Angle Decimal Point
Tool
Data
<*Cannot be
changed>
00 10 Connected Tool No.
00 11 Tool CAL Torque Kgm
00 12 Tool CAL Voltage V
00 13 Tool Zero Torque Voltage V
00 14～1A In-house Management Data
00 1B/1C Tool Fastening Count (First 4 digits/ last 4 digits)
Tool type 00 20 Tool No.
Time
(only avail.)
(w/SAN3-DPx)
00 30 Date: Year “2009” 2009
00 31 Date: Month / Day “705” 07 / 05
00 32 Time: Hours / Minutes “1510” 15:10
00 33 Time: Seconds “43” :43
○ Available × Cannot be changed
Item
[Unit]
Parameter No.
PARM
Data No.
D-NO
DATA
Torque
Method
Angle
Method
Offset
Check
Fastening
01~16 00 Fastening Mode (Step + Method) XXX0 XXX1 XXXX
01~16 05 Fastening Option 1 0000 0000 0200
01~16 06 Fastening Option 2 ○ ○ ○
Torque
[Nm]
01~16 10 Calibration torque (CAL value) ○ ○ ○
01~16 11 Peak Low Torque Limit ○ ○
01~16 12 Peak High Torque Limit ○ ○
01~16 13 Standard Torque ○
01~16 14 Speed Change Torque ○ ○
01~16 15 1ST Torque ○ ○
01~16 16 Snug Torque ○ ○
01~16 17
Threshold Torque
(1
st
torque rate start torque)
○ ○
01~16 18
Crossover Torque
(3 rd torque rate start torque)
○ ○
01~16 19 Torque Inhibit Limit ○ ○ ○
01~16 1A
Offset Torque Limit ○
1 Pulse Reverse Torque Limit ○ ○
01~16 1B Breakaway Torque Limit ○ ○
01~16
1C Final Low Torque Limit ○ ○
01~16 1D Final High Torque Limit ○ ○
01~16 1E 2ND Rate Start Torque ○ ○
Angle
[deg]
01~16 20 Low Angle Limit ○ ○
01~16 21 High Angle Limit ○ ○
01~16 22 Standard Angle ○
01~16 23 1ST Angle ○
01~16 24
Crossover Angle
(3
rd
torque rate start angle)
○
01~16 25 Angle Correction ○ ○
01~16 26 2
nd
Rate Start Angle (Not Used) Ч ○