FEC AFC1500 - Manual (Page 102)

Chapter 6: Fastening Instructions
Page 6-16
6.2.3 Angle Monitoring
Angle Monitoring commences upon reaching the preset SNUG TORQUE value, and continues until
completion of the fastening process.
P In Angle Control method, the Angle High and Low Limits are set based upon the engineering speci-
fication for that specific fastener.
ANGLE CONTROL
REJECT TYPE CAUSES
ANGLE HIGH LIMIT Incorrect parameter set-up.
ANGLE LOW LIMIT Reject condition caused by another monitor item reject.
Peak Torque High Limit
Peak Torque Low Limit
Torque
Angle/Time
Snug Torque
Threshold Torque
Speed Change Torque
1 st Torque
Crossover Torque
Final Time 1 st Time
Standard
Angle
Angle High Limit Angle Low Limit
Final Torque High Limit
Final Torque Low Limit