FEC AFC1500 - Manual (Page 142)

Chapter 7: System Operations
Page 7-28
7.3.6 Parameter copy.
To speed parameter data entry, it may be beneficial to copy from one parameter set to another pa-
rameter set. This is especially the case if only minor changes are required. Use the procedure be-
low for the parameter copy function using the display;
wWhen the system is in Setup mode, select
Data number 01 of Parameter 00. (This data
corresponds to the ROM version and is non
adjustable data.)
wPress the Set button and the cursor will
jump to the left digit position of the 4 digit
data display. (There will be a decimal point
between the second and third digit) The first
two digits specify which parameter number
is to be copied FROM and the two digits af-
ter the decimal point specify which parame-
ter number is being copied TO.
wEdit the numbers to change the display to
get the desired source and target parameter
numbers. (The example to the left shows
parameter 1 being copied to parameter 2)
wPress the SET button to proceed with the
copy.
wPress either arrow button to confirm the
change (YES) or to cancel it (NO). (The dis-
play will return to the Setup Mode if no ac-
tion is taken within 4 seconds)
wIf YES is displayed, press the SET button
again to copy the parameter.
FIG. 7.3.6 Parameter copy procedure.