FEC AFC1500 - Manual (Page 154)

Chapter 8: System Operations
Page 8-10
8.3.2 Replace Nutrunner (tool).
Do not attempt to replace a component of the tool - the tool must be replaced as a complete
assembly. The tool type identification can be found on the identification tag affixed to the tool
and on the System [TOOL TYPE] preset value.
1. Verify all System power is off.
2. Ensure that the two (2) homerun cables are marked for reconnection, then disconnect them from
the tool.
3. Ensure the spindle assembly is supported, and remove the two (2) bolts securing it to the mount-
ing plate.
WARNING: These two (2) bolts also secure the nutrunner, with the two (2) bolts removed in
the next step. Some tool models are very heavy. Use precautions when disconnecting, re-
moving, and installing these components.
4. Ensure the nutrunner is supported, and remove the two (2) remaining bolts (two of the four were
removed in Step 3).
5. Follow all safety precautions to install an identical nutrunner assembly by performing the removal
procedure in reverse order.
8.3.3 Replace homerun cables
FEC INC. provides a spare set of homerun cables with each System. (Units purchased as compo-
nents, may not come with spare cables sets)
1. Verify all System power is off.
2. Disconnect the damaged cable(s) from the nutrunner and the SAN unit, and replace with the spare
cable(s).