FEC AFC1500 User Manual
Page 12
4.7.5 PLC Wiring Sample
4-22
4.7.6 Synchronized Fastening Operation(Without MULTI UNIT)
4-23
4.7.7 Signal Timing Chart
4-24
4.8 RS-485 Data communication ports.
4-26
4.9 MON. Connector -Torque/Angle/Current/Speed OUTPUT
4-27
4.9.1 Monitoring connector Output Circuit.
4-28
4.10 SAN Unit DIP Switch setting.
4-29
4.10.1 SAN Unit DIP switch positions 1 ~ 3
4-29
4.10.2 SAN Unit DIP switch positions 4 ~ 8
4-30
4.11 Tool Connection (cabling)
4-31
4.11.1 Cable Installation Guidelines
4-32
4.11.2 Considerations for Cable Trolleys
4-33
4.11.3 Considerations for Flexible Cable Tracks
4-33
4.11.4 Considerations for Cable Trays and Ladders
4-33
4.11.5 Preamplifier connector.
4-34
4.11.6 Motor connector
4-34
4.11.7 Resolver connector
4-35
4.12 Firmware Flash Connector (CN8).
4-36
Chapter 5: Power Up and Initial Checks
5-1
5.1 Before Powering On
5-2
5.2 Initial Data Setting
5-3
Chapter 6: Fastening Instructions
6-1
6.1 Fastening Control
6-2
6.1.1 Torque Control Method
6-2
6.1.2 Angle Control Method
6-6
6.2 Monitoring Functions
6-12
6.2.1 Peak Torque Monitoring
6-12
6.2.2 Final Torque Monitoring
6-14
6.2.3 Angle Monitoring
6-16
6.2.4 Point-to-Point Torque Rate Monitoring
6-18
6.2.5 Time Monitoring
6-20
6.3 Speed Functions
6-21
6.4 Reverse Functions
6-23
6.5 Torque Recovery
6-24
6.6 Added Functions
6-25
6.6.1 Current Monitor / Control
6-25
6.6.2 Offset Check / Offset Correct
6-26
6.6.3 Angle Correction
6-26
6.6.4 One Pulse Reverse Function
6-26
6.6.5 Quarter Torque Recovery
6-27
6.6.6 Reduced Fastening Reaction
6-27
6.6.7 Varispeed
6-27
6.6.8 Rundown Revolution Limits
6-28
6.6.9 Torque Inhibit Function
6-28
6.6.10 Fastening End by Self Check Off Signal
6-28
Chapter 7: System Operations
7-1
7.1 AFC1500 Detachable Display and Programming unit operation.
7-2
7.1.1 Manual Fastening controls for Display Programming (DP) Unit
7-2
7.1.2 Fastening Preset Results Display
7-3
7.1.3 Fastening Presetting / Result Display Controls
7-3
7.2 Run State Modes.
7-4
7.2.1 Display indication modes.
7-4