FEC AFC1500 - Manual (Page 120)

Chapter 7: System Operations
Page 7-6
7.2.3 Fastening Results Display Mode.
In Fastening Results Display mode (when [D-NO] shows _0 ~

), data can be obtained by
pressing the [  ] and [  ] keys to scroll the [D-NO] until the desired DATA item is displayed.
The following information will be displayed in the [DATA] display section for the displayed
[D-NO]:
D-NO DATA Unit *
_0 Peak Torque Value (Judgment torque value) Nm
_1 Final Angle Value deg
_2 1ST Torque Rate Value Nm/deg
_3 2ND Torque Rate Value Nm/deg
_4 1ST Area Fastening Time Sec
_5 Final Area Fastening Time Sec
_6 Cycle Time Sec
_7 Fastening Mode No.
_8 3RD Torque Rate Value Nm/deg
_9 
Not Used

0 Fastening Method No.
=1 Step
=2 Not Used
=3 Self Check ON: Checked OFF: Unchecked
=4 Reverse Flag ON: Reversed OFF: Not reversed
=5
Cause of Fastening stop 0: Reset / No data / After reverse
1: Abnormal 2: BYPASS signal 3: Stop signal
4: REJECT 5: ACCEPT (Normal)
=6 Torque Judgment tq H/L (Final) H/L (Peak)
=7 Angle Judgment An H/L (Angle)
=8 Torque Rate Judgment r H/L (1ST) H/L (2ND) H/L (3RD)
=9 Time Judgment ti H/L (1ST) H/L (FNL) /
r (left) = Low rundown rev
– r (right) = High rundown rev

0 1ST Torque Rate Area Increment Torque Nm
 1 2ND Torque Rate Area Increment Torque Nm

2 Offset Torque Nm
 3 1ST Peak Torque Nm

4 Final Torque Value Nm
 5 Angle at Peak Torque (Judgment Torque) deg

6 Maximum Current Value A

Not Used

Unit of measure for Torque can be Nm, Kgm, Kgcm, Ftlb or Inlb
FIG. 7-2-3 Fastening results display selection