FEC AFC1500 - Manual (Page 97)

FEC AFC1500 Operations Manual Chapter 6: Fastening Instructions (Rev. 6: 10/09)
Page 6-11
NOTE: When performing multiple step Angle control fastening, the rotation Angle should be
performed as one continuous operation. There should be no intermediate stop / synchroniza-
tion points once Snug Torque has been sensed and rotation angle is being controlled.
Under special conditions multiple steps can be performed using intermediate Torque or Angle
stop/synchronization points as shown below.
FIG. 6-1-2d Angle Control Functions for Three-Step Fastening
1 st Time Final Time
Standard
Angle
Snug Torque
Threshold Torque
Speed Change Torque
1 st Torque
Crossover Torque/Angle