1 san(3)-dp2/dp4 serial pin out – FEC AFC1500 User Manual
Page 39
FEC AFC1500 Operations Manual
Chapter 3: System Description
(Rev. 6:10/09)
Page 3-9
3.4
AFC1500 Keyboard-Display Unit - SAN DP2/DP4 – SAN3-DP2
The SAN(3)-DP2 has the same function as the DP1 unit with the added function of a serial RS232
port for output of fastening data from a stand alone single SAN Unit. If the SAN unit is part of a mul-
tiple spindle configuration, then the fastening data would be output from the Multi Unit and this display
would not be required for this purpose. All button functions are identical to the DP1 Unit.
NOTE: Refer to Chapter 7 for detailed operation using the SAN(3)-DP units.
Fig. 3-4 SAN - DP2 Unit
3.4.1 SAN(3)-DP2/DP4 Serial Pin out
Connector: DB-9P (Male)
Mating Connector: DB-9S (Female)
PIN
SIGNAL
DESCRIPTION
1
NOT USED
2
RXD
NOT USED
3
TXD
TRANSMIT DATA
4
DTR
DATA TERMINAL READY (ALWAYS ON)
5
GND
SIGNAL GROUND
6
DSR
NOT USED
7
RTS
REQUEST TO SEND (ALWAYS ON)
8
CTS
CLEAR TO SEND
9
NOT USED
Note: The CTS signal needs to be activated in order for the fastening data to be output. If it is
not activated, up to 16KB of data will be stored in the output buffer. Once the buffer is full, the
data will be overwritten in a First In, First Out (FIFO) process. The CTS signal may be con-
nected to the RTS signal if data is to be “dumped” at every fastening.
1
5
6
9
SAN-DP2
Mounting
flange on
DP3 and
DP4 only
The SAN display units come in (2) different widths
to allow mounting to the SAN Units
SAN-DP1 & DP2 can be used on the following SAN
Units:
•
SAN2-12, SAN2-40,
SAN3-24(H), SAN3-40, SAN3-60H
SAN-DP3 & DP4 can be used on the following SAN
Units;
•
SAN2-80, SAN2-120,
SAN3-120T, SAN3-120W
(These units have a wider mounting flange)
SAN3-DP1 & DP2 units were introduced in 2009
and are RoHs compatible replacements of the 1
st
generation SAN-DP units. These units also include
the addition of a real time clock (RTC) function for
stand-alone systems. (see 7.2.5 Parameter Data
List for clock setup)
SAN3-DP1 & SAN3-DP2 can now be used on ALL
SAN units. (DP2 has a serial port)