FEC AFC1500 - Manual (Page 132)

Chapter 7: System Operations
Page 7-18
Data No.20 Low Angle [deg]
Data No.21 High Angle [deg]
Setting range: 0~9999
Sets the High and Low limits for Fastening Judgment Angle as measured from [16:SNUG
Torque] to Fastening End. If the High limit is reached the fastening operation will stop even if
the operation is not complete.
Data No.22 Standard Angle [deg]
Setting range: 0~9999
Sets the target Angle value for fastening as measured from [16:SNUG Torque].
This is only available when [00: Fastening Mode] is Angle Mode.
Data No.25 Correction Angle [deg]
Setting range: 0~99
Compensation value for when the Final Angle value of the equipment does not match the value
read from an external master device.
Normally, this value shall be set as 0.
Data No.30 1
st
Rate Low Limit [Nm/deg]
Data No.31 1
st
Rate High Limit [Nm/deg]
Setting range: 0~Tool type ’s maximum torque rate
Sets the high and low limits for the Torque rate measured between the two points
[17:Threshold Torque] and [15:1ST Torque] or [23:1
st Angle].
Judgment is conducted at the point when [15:1ST Torque] or [23:1
st
Angle] is achieved or when
Fastening ends, whichever occurs first.
Data No.32 2
nd
Rate Low Limit [Nm/deg]
Data No.33 2
nd
Rate High Limit [Nm/deg]
Setting range: 0~Tool type ’s maximum torque rate
Sets the high and low limits for the Torque rate measured between the two points
[1E:2
nd
Rate Start Torque] or [26:2
nd
Rate Start Angle] and [18:CROS Torque] or
[24:CROS Angle].
Judgment is conducted at the point when the [18:CROS Torque] or [24:CROS Angle] is
reached or when Fastening ends, whichever occurs first.
Data No.34 3
rd
Rate Low Limit [Nm/deg]
Data No.35 3
rd
Rate High Limit [Nm/deg]
Setting range: 0~Tool type ’s maximum torque rate
Sets the high and low limits for the Torque rate measured between the two points
[18:CROS Torque] or [24:CROS Angle] and Fastening End.