FEC DSP1500 (SAN3) - Manual (Page 102)

enFORCE DSP1500 SAN Unit Operation Manual
(Rev 4) PAGE 6－26
Chapter 6: System Operation
♦ Distance Control (Method 1)
Upon start of cycle, the press will operate until it achieves [33: Target Distance].
During the press cycle, checks are performed for “Interference Check” / “Part Check”,
Load and Distance. If any of these values are compromised, the press will stop and
return as programmed.
(See corresponding sections for Interference Check and Part Check explanations.)
Load
Distance
[13] Load High Limit
[12] Load Low Limit
[31]
Distance
Low Limit
[32]
Distance
High Limit
Final Judgment Zone
[33]
Target
Distance