FEC DSP1500 (SAN3) - Manual (Page 84)

enFORCE DSP1500 SAN Unit Operation Manual
(Rev 4) PAGE 6－8
Chapter 6: System Operation
6.3.2 Mode Change
Three display modes can be selected while in the RUN state by pressing the [MODE] button.
In addition, the values of each mode can be scrolled through by pressing the [↑] and [↓] buttons.
When the unit powers on, the display defaults to the Real Time Display Mode.
When the press cycle starts, the display switches to the Operating Condition Display until the end
of cycle. At that time the display switches to the Press Result Display Mode.
Mode displays cannot be changed with the buttons during a press cycle.
The result details can be scrolled through with the
[↑] and [↓] buttons.
It is only displayed at the end of the press
operation.
PAGE 6-11
Displayed set values can be scrolled through with
the [↑] and [↓] buttons.
PAGE 6-12
When the power is turned on, the default display
mode is the Real Time Display Mode.
Display contents can be scrolled through with the
[↑] and [↓] buttons.
See table for data number.
PAGE 6-10
[Status Display] will be displayed when
abnormalities occur or when the STOP or Limit
signals are OFF.
PAGE 6-13
Press Result
Display Mode
Parameter
Display Mode
Real Time
Display Mode
Status
Display
Power ON
START
START
MODE
MODE
MODE
MODE