FEC DSP1500 (SAN3) - Manual (Page 149)

enFORCE DSP1500 SAN Unit Operation Manual
PAGE 8－15 (Rev. 4)
Chapter 8: Troubleshooting
• Code A9_6 - PARAMETER ERROR / DISTANCE SETUP ERROR
One of the Distance presets is out of range
RECOVERY:
1. Verify that the Distance presets are in range for the tool size.
2. Check that the Distance presets are not <0> or setup as specified in 6.4.5.2.
• Code A9_7 - PARAMETER ERROR / RETURN LOAD OVER.
The Return Load is more than 1/6 of the Full Scale Load.
RECOVERY:
1. Verify there is no excessive binding in the press shaft or press fixture while running in the
return portion of the press stroke.
2. Verify that the brake has been released while running a return operation.
3. If heavy tooling is attached to the press ram causing an excessive load to be seen, set the
“Self Check Off” signal high (on) before sending a “Start” signal.
• Code A9_8 - PARAMETER ERROR / ADVANCE JOG LOAD OVER.
The Advance Jog Load is more than 1/6 of the Full Scale Load.
RECOVERY:
1. Verify there is no excessive binding in the press shaft or press fixture while jogging forward in
manual mode.
2. Verify that the brake has been released while performing a forward jog operation.
• Code A9_9 - PARAMETER ERROR / HOME SEARCH LOAD OVER.
The Home Search Load is more than 1/6 of the Full Scale Load.
RECOVERY:
1. Verify there is no excessive binding in the press shaft or press fixture while performing a
Home Position Search.
2. Verify that the brake has been released while performing a Home Position Search.
• Code A9_10 - PARAMETER ERROR / HOME RETURN LOAD OVER.
The Home Return Load is more than 1/6 of the Full Scale Load.
RECOVERY:
3. Verify there is no excessive binding in the press shaft or press fixture while performing a
Home Return operation.
4. Verify that the brake has been released while performing a Home Return operation.