FEC DSP1500 (SAN3) - Manual (Page 94)

enFORCE DSP1500 SAN Unit Operation Manual
(Rev 4) PAGE 6－18
Chapter 6: System Operation
6.4.5 Data Number Definitions
6.4.5.1 System Parameter: Parameter Number 00
¾ Data Number 00 Load Unit
Load Unit 0: KN 1: KLBS 2: METRIC TON
¾ Data Number 01 S P Version
This is the Unit Software Version. No changes can be made.
However, the [DATA] fields are made available for Parameter Copying.
The first two digits of the [DATA] section are for the Parameter number to
copy from and the second two digits are for the Parameter number to copy to.
See Page 6-16 for operation method.
¾ Data number 02 Preamplifier Version
This is the preamplifier version. No changes can be made.
¾ Data number 03 Functioning Version
Used for special function settings. The following values are set at the factory
depending on which configuration is required. This value should not be
changed without first consulting FEC.
SAN Unit (Main Configuration): 0180
SAN Unit (Stand Alone Configuration): 0103
Item
PARAMETE
RPARM
DATA NO.
D-NO
DATA
System
００ ００ Load Unit 0: KN 1: KLBS 2: METRIC TON
００ ０１ SP Version / Parameter Copy (cannot change version)
００ ０２ Amplifier Version (no change allowed)
００ ０３ Function Version (0103=Stand Alone / 0180=with Main)
００ ０４ Offset Load [KN]
００ ０５ Distance Compensation [mm]
００ ０６ No Load Current Limit 0～1023
００ ０７ Current Load Conversion Ratio ％
００ ０８ Home Position Offset [mm]
００ ０９ Resolver Position 0～4095
Tool
Data
(No
Change)
００ １０ Tool Number
００ １１ Tool Calibration Load [KN]
００ １２ Tool Calibration Voltage [Ｖ]
００ １３ Tool Zero Load Voltage [Ｖ]
００ １４～１Ａ In House Control Data
Tool Type ００ ２０ Tool Number
System
００ ３０ Home Position Search Timeout 0.1[sec] increments
００ ３１ Home Position Search Speed [mm/s]
００ ３２ Manual Operation Speed [mm/s]
００ ３３ Stroke Distance Limit [mm]
００ ３４ Approach Distance Limit [mm]
００ ３５ Home Returned Signal Output Range [mm]
００ ３６ Option Setting 1
００ ３７ Option Setting 2
００ ３８ Option Setting 3
００ ３９ Option Setting 4
Real Time
Clock
００ ４０ RTC Date: Year “2008” = 2008
００ ４１ RTC Date: Month / Day “705” = July 5th
００ ４２ RTC Time: Hours / Minutes “1510” = 3:10PM
００ ４３ RTC Time: Seconds “50” = :50