FEC DSP1500 (SAN3) - Manual (Page 126)

enFORCE DSP1500 SAN Unit Operation Manual
(Rev 4) PAGE 7－2
Chapter 7: Maintenance & Inspection
7.1 Inspection Items
A scheduled inspection is recommended to keep the enFORCE System in the best running
condition. A preventive maintenance routine should be set-up. Recommended inspection schedules
are given for each item.
Follow Lockout/Tagout and other safety precautions when connecting or
disconnecting cables, wiring, and equipment. When performing the following
inspections, verify that the System is disabled prior to touching any moveable
components.
7.1.1 Press Tool
Recommended Schedule: Quarterly
It is important to keep the tool clean and properly adjusted to ensure correct press and accurate
system outputs. Inspect each tool, and ensure the following conditions exist:
• All environmental conditions are within the specified ranges.
• The duty cycle is within specifications, and the motor is producing normal heat levels.
• The tool is producing normal levels of noise and vibration.
• The tool is free from excessive contamination and foreign matter.
• The tool is securely mounted, with mounting bolts properly tightened.
• The homerun cables are securely connected to the tool.