FEC DSP1500 (SAN3) - Manual (Page 123)

enFORCE
DSP1500 SAN Unit Operation Manual
PAGE 6－47 (Rev 4)
Chapter 6: System Operation
6.6 Return Parameter Setup
It is recommended that, if the return of the press is done with a parameter, use Distance Control.
However, if Target Distance is set to 0 without a return operation, the press will reject because the
Distance Low value is zero (a value less than zero is not possible).
Refer to the following for setting up a Return Parameter. Adjustments can be made according to
the individual application.
D-NO DATA SETTING
00 Press Operation ０００１ (Distance Control＋Return Operation)
12 Load Low Limit ０
13 Load High Limit Maximum Load of the Tool
15 Interference Check Load Maximum Load of the Tool
16 Press Speed 1 Start Load 1 or Maximum Load of the Tool
17 Press Speed 2 Start Load Same as Press Speed 1 Start Load
18 Distance Measurement Start Load ０
22 Part Check 1 Load ０ . １
31 Distance Low Limit ０
32 Distance High Limit ２
33 Target Distance １ (setting to 0 will cause a reject)
35 Approach Distance １０ (may need to set larger for higher speeds)
36 Interference Check Distance ０ (unless required)
37 Press Speed 1 Start Distance ３
38 Press Speed 2 Start Distance ２
41 Job Start Position ０
42 Part Check 1 Distance Low Limit ０
43 Part Check 1 Distance High Limit Maximum Stroke of the Tool
50 Advance Position ON Distance ０
51 Advance Position OFF Distance ０
52 Return Position ON Distance ０
53 Return Position OFF Distance ０
60 Slow Start Time ０ . １
61 Load Hold Time ０
70 Slow Start Speed １
71 Approach Speed １００
72 Part Search Speed １０
73 Press Speed 1 ３
74 Press Speed 2 １
75 Decompression Speed ５
76 Return Speed ５