FEC DSP1500 (SAN3) User Manual
Page 19
enFORCE
DSP1500 SAN Unit Operation Manual
PAGE 1－5 (Rev.
4)
Chapter 1: Outline
¾ Electrical Noise Prevention
• SAN units must be located a minimum of 600mm from high transient voltage sources such
as transformers, motor starters, AC inverters and AC contactors. If it cannot be avoided, the
unit must be shielded.
• If high powered devices are used inside the enclosure, they must use a surge suppression
device.
• Make sure that the power supply lines and cables for connecting the unit and tool are not run
together inside the same duct.
¾ Handling and Shipping
• It is critical that
enFORCE
System components are properly handled and shipped in order
to maintain the system’s integrity. Adhere to the following requirements for shipping and
handling:
Loose
enFORCE
System components must be individually packaged and shipped
in anti-static containers or wrap to prevent damage from electrostatic discharge.
If the SAN unit is to be shipped in an enclosure, tighten all mounting screws to prevent
the unit from being dislodged.
Do not package the tool with the weight of the unit resting on the press ram as
damage to the load cell may occur.
The tool is heavy. Use lifting rings provided when necessary to move the tool.
Enclosure must be protected with shrink wrap.
Enclosure and system components should be shipped on an air ride trailer whenever
possible.
All non-painted metal parts (except the electric motor and connectors) must be
greased or oiled to prevent rust.
Do not ship or store the system components in environments where the temperature
is out of the 23~131℉ (-5~55℃) range or where the humidity is above 90%.
1.4 Safety Labels
Various labels are used on the SAN Unit and Press Tool to warn of possible harm or injury. These
labels should be taken very seriously. Refer to the following page for label location.
HIGH VOLTAGE:
Do not touch exposed connector
terminal. May cause electric shock. Disconnect power before
servicing.
DANGER
CAUTION
HOT SURFACE:
Do not touch heatsink.
May cause burn.
Use proper grounding techniques.
May cause electric shock.
DANGER
Do not disassemble
May result in
serious injury
Pinch Point
Watch your hands
Keep away
DANGER
CAUTION
HOT SURFACE
Do not touch
HIGH VOLTAGE
HOT SURFACE
PROPERLY GROUND