FEC DSP1500 (SAN3) User Manual
Page 114
enFORCE
DSP1500 SAN Unit Operation Manual
(Rev 4)
PAGE 6－38
Chapter 6: System Operation
¾
Data Number 70 - Slow Start Speed
Ramp up speed value at start of cycle. Slow Start Speed is performed during [60: Slow
Start Time].
A setting is possible from tool minimum speed to tool maximum speed.
¾
Data Number 71 - Approach Speed
Higher speed value used for the “no-load” portion of the press operation. The
press will run at this speed until [35: Approach Distance], [37: Press Speed
1 Start Distance], [16: Press Speed 1 Start Load], [38: Press Speed 2
Start Distance] or [17: Press Speed 2 Start Load] is reached. Begins after
[60: Slow Start Time] has passed.
A setting is possible from tool minimum speed to tool maximum speed.
¾
Data Number 72 - Part Search Speed (Recommended less than 50mm/sec. or 1/4 or
less of the tool’s maximum speed)
Slower speed value used when nearing the part. The press will run at this speed until
[37: Press Speed 1 Start Distance], [16: Press Speed 1 Start Load], [38: Press
Speed 2 Start Distance] or [17: Press Speed 2 Start Load] is reached. Begins after
[35: Approach Distance] is reached.
¾
Data Number 73 - Press Speed 1 (Recommended less than 20mm/ sec. or 1/4 or
less of the tool’s maximum speed)
Slowest speed value used for the “load” portion of the press operation. Begins after [37:
Press Speed 1 Start Distance] or [16: Press Speed 1 Start Load] is reached.
¾
Data Number 74 - Press Speed 2 (If unused set equal to Press Speed 1)
(for distance accuracy set <=3mm/sec.)
Slowest speed value used for the “load” portion of the press operation. May be used in
conjunction with [73: Press Speed 1] to slow the press even more to obtain distance
accuracy. Begins after [38: Press Speed 2 Start Distance] or [17: Press Speed 2 Start
Load] is reached.
This speed is also used to control the press during [61: Load Hold Time].
If not used, set same as [73: Press Speed 1].
¾
Data Number 75 - Decompression Speed
After completing the press operation, the press will return at this speed until the load has
reached a value close to zero then will switch to [76: Return Speed].
The press operates at this speed when performing a “Load Return” operation.
On “F-type” presses the time the press can operate under load at this speed is
approximately 1 sec.
A setting is possible from tool minimum speed to tool maximum speed.
¾
Data Number 76 - Return Speed
Speed at which the press will return to the [41: Job Start Position] after the pressing
operation is complete and the load has been released (decompressed).
A setting is possible from tool minimum speed to tool maximum speed.
Speed Settings