Yokogawa Single Channel Oxygen Analyzer System ZR22/ZR402 - Manual (Page 63)

IM 11M13A01-02E 3-12
A pipe to be mounted (nominal JIS 50A)
Bracket
Nut
Washer
Bolt
*Screw
*Washer
*Fitting
* Note: These fittings are attached to the equipment when it is delivered.
F3.08E.EPS
᭹ Mounting procedure
1. Put four bolts in the holes on the fitting.
2. Clamp the pipe with the fitting and a bracket,
with the four bolts passing through the bracket holes.
3. Secure the fitting and the bracket tightly to the pipe with
four washers and nuts.
Figure 3.8 Pipe Mounting
<Wall Mounting>
(1) Drill mounting holes through the wall as shown in Figure 3.9.
190
126.5
Four holes 6 mm in diameter
for M5 screws
Unit: mm
F3.09E.EPS
Figure 3.9 Mounting holes
(2) Mount the converter. Secure the converter on the wall using four screws.
Note: For wall mounting, the bracket and bolts are not used.
F3.10E.EPS
Figure 3.10 Wall Mounting