Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 100)

44 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
4
General Commands
reload (Privileged Exec)
This command restarts the system.
NOTE
When the system is restarted, it will always run the Power-On Self-Test. It will also retain all
configuration information stored in non-volatile memory by the copy running-config startup-config
command.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
This command resets the entire system.
Example
This example shows how to reset the switch:
Console#reload
System will be restarted, continue <y/n>? y
show reload
This command displays the current reload settings, and the time at which next scheduled reload
will take place.
Command Mode
Privileged Exec
Example
Console#show reload
Reloading switch in time: 0 hours 29 minutes.
The switch will be rebooted at January 1 02:11:50 2001.
Remaining Time: 0 days, 0 hours, 29 minutes, 52 seconds.
Console#
end
This command returns to Privileged Exec mode.
Default Setting
None
Command Mode
Global Configuration, Interface Configuration, Line Configuration, VLAN Database Configuration,
and Multiple Spanning Tree Configuration.