Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 212)

156 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
9
AAA
Default Setting
None
Command Mode
Server Group Configuration
Command Usage
• When specifying the index for a RADIUS server, that server index must already be defined by
the
radius-server host command.
• When specifying the index for a TACACS+ server, that server index must already be defined by
the
tacacs-server host command.
Example
Console(config)#aaa group server radius tps
Console(config-sg-radius)#server 10.2.68.120
Console(config-sg-radius)#
accounting dot1x
This command applies an accounting method for 802.1X service requests on an interface. Use the
no form to disable accounting on the interface.
Syntax
accounting dot1x {default | list-name}
no accounting dot1x
default - Specifies the default method list created with the aaa accounting dot1x
command.
list-name - Specifies a method list created with the aaa accounting dot1x command.
Default Setting
None
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/2
Console(config-if)#accounting dot1x tps
Console(config-if)#