Spanning-tree mst port-priority – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 403

Advertising
background image

Brocade 6910 Ethernet Access Switch Configuration Guide

347

53-1002651-02

18

Spanning Tree Commands

Command Mode
Interface Configuration (Ethernet, Port Channel)

Command Usage

•

Each spanning-tree instance is associated with a unique set of VLAN IDs.

•

This command is used by the multiple spanning-tree algorithm to determine the best path
between devices. Therefore, lower values should be assigned to interfaces attached to faster
media, and higher values assigned to interfaces with slower media.

•

Use the no spanning-tree mst cost command to specify auto-configuration mode.

•

Path cost takes precedence over interface priority.

Example

Console(config)#interface Ethernet 1/5

Console(config-if)#spanning-tree mst 1 cost 50

Console(config-if)#

Related Commands

“spanning-tree mst port-priority”

on page 347

spanning-tree mst port-priority

This command configures the interface priority on a spanning instance in the Multiple Spanning
Tree. Use the no form to restore the default.

Syntax

spanning-tree mst instance-id port-priority priority

no spanning-tree mst instance-id port-priority

instance-id - Instance identifier of the spanning tree. (Range: 0-4094)

priority - Priority for an interface. (Range: 0-240 in steps of 16)

Default Setting
128

Command Mode
Interface Configuration (Ethernet, Port Channel)

Command Usage

•

This command defines the priority for the use of an interface in the multiple spanning-tree. If
the path cost for all interfaces on a switch are the same, the interface with the highest priority
(that is, lowest value) will be configured as an active link in the spanning tree.

•

Where more than one interface is assigned the highest priority, the interface with lowest
numeric identifier will be enabled.

Example

Console(config)#interface Ethernet 1/5

Console(config-if)#spanning-tree mst 1 port-priority 0

Console(config-if)#

Advertising