Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 185)

Brocade 6910 Ethernet Access Switch Configuration Guide 129
53-1002651-02
7
Remote Monitoring Commands
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rmon collection history controlentry 21 owner mike buckets 24
interval 60
Console(config-if)#
rmon collection rmon1
This command enables the collection of statistics on a physical interface. Use the no form to
disable statistics collection.
Syntax
rmon collection rmon1 controlEntry index [owner name]
no rmon collection rmon1 controlEntry index
index – Index to this entry. (Range: 1-65535)
name – Name of the person who created this entry. (Range: 1-127 characters)
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
• By default, each index number equates to a port on the switch, but can be changed to any
number not currently in use.
• If statistics collection is already enabled on an interface, the entry must be deleted before any
changes can be made with this command.
• The information collected for each entry includes:
input octets, packets, broadcast packets, multicast packets, undersize packets, oversize
packets, fragments, jabbers, CRC alignment errors, collisions, drop events, and packets of
specified lengths
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rmon collection rmon1 controlEntry 1 owner mike
Console(config-if)#
show rmon alarms
This command shows the settings for all configured alarms.
Command Mode
Privileged Exec
Example
Console#show rmon alarms
Alarm 1 is valid, owned by
Monitors 1.3.6.1.2.1.16.1.1.1.6.1 every 30 seconds
Taking delta samples, last value was 0