Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 837)

Brocade 6910 Ethernet Access Switch Configuration Guide 781
53-1002651-02
36
Changing the Aging Time
Changing the Aging Time
Use the MAC Address > Dynamic (Configure Aging) page to set the aging time for entries in the
dynamic address table. The aging time is used to age out dynamically learned forwarding
information.
CLI References
• “mac-address-table aging-time” on page 323
Parameters
These parameters are displayed:
• Aging Status – Enables/disables the function.
• Aging Time – The time after which a learned entry is discarded. (Range: 10-844 seconds;
Default: 300 seconds)
Interface
To set the aging time for entries in the dynamic address table:
1. Click MAC Address, Dynamic.
2. Select Configure Aging from the Action list.
3. Modify the aging status if required.
4. Specify a new aging time.
5. Click Apply.
FIGURE 113 Setting the Address Aging Time