Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1073)

Brocade 6910 Ethernet Access Switch Configuration Guide 1017
53-1002651-02
43
Connectivity Fault Management
To show single-ended loss-measure attribute groups:
1. Click Administration, CFM.
2. Select Configure Periodic Loss Measure from the Step list.
3. Select Show Single-Ended LM Group from the Action list.
FIGURE 309 Showing Single-Ended Loss-Measure Attribute Groups
To transmit periodic single-ended loss-measure messages:
1. Click Administration, CFM.
2. Select Configure Periodic Loss Measure from the Step list.
3. Select Configure Single-Ended LM from the Action list.
4. Select the index for the MD, MA and MEP, and then click Query.
5. Mark the Status box to enable periodic transmission of loss-measure messages.
6. Select one of the group indexes.
7. Specify the target MEP identifier.
8. Click Apply.
FIGURE 310 Transmitting Single-Ended Loss-Measure Messages
To transmit periodic dual-ended loss-measure messages:
1. Click Administration, CFM.
2. Select Configure Periodic Loss Measure from the Step list.