Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 954)

898 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
42
Access Control Lists
Interface
To bind an ACL to a port:
1. Click Security, ACL.
2. Select Configure Interface from the Step list.
3. Select Configure from the Action list.
4. Select IP, MAC or IPv6 from the Type list.
5. Select a port.
6. Select the name of an ACL from the ACL list.
7. Click Apply.
FIGURE 214 Binding a Port to an ACL
Configuring ACL Mirroring
After configuring ACLs, use the Security > ACL > Configure Interface (Add Mirror) page to mirror
traffic matching an ACL from one or more source ports to a target port for real-time analysis. You
can then attach a logic analyzer or RMON probe to the target port and study the traffic crossing the
source VLAN(s) in a completely unobtrusive manner.
CLI References
• “Local Port Mirroring Commands” on page 297
Command Usage
ACL-based mirroring is only used for ingress traffic. To mirror an ACL, follow these steps:
1. Create an ACL as described in the preceding sections.
2. Add one or more mirrored ports to ACL as described under “Binding a Port to an Access Control
List” on page 897.