Enable – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 97
Brocade 6910 Ethernet Access Switch Configuration Guide
41
53-1002651-02
4
General Commands
Command Usage
•
This command resets the entire system.
•
Any combination of reload options may be specified. If the same option is re-specified, the
previous setting will be overwritten.
•
When the system is restarted, it will always run the Power-On Self-Test. It will also retain all
configuration information stored in non-volatile memory by the
running-config
startup-config
command (See
Example
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2007 ---
***
Are you sure to reboot the system at the specified time? <y/n>
enable
This command activates Privileged Exec mode. In privileged mode, additional commands are
available, and certain commands display additional information. See
Syntax
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec, 15: Privileged Exec. Enter
level 15 to access Privileged Exec mode.
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
•
“super” is the default password required to change the command mode from Normal Exec to
Privileged Exec. (To set this password, see the
command.)
•
The “#” character is appended to the end of the prompt to indicate that the system is in
privileged access mode.
Example
Console>enable
Password: [privileged level password]
Console#
Related Commands