Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 156)

100 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
5
Time
Related Commands
“show sntp” on page 95
calendar set
This command sets the system clock. It may be used if there is no time server on your network, or if
you have not configured the switch to receive signals from a time server.
Syntax
calendar set hour min sec {day month year | month day year}
hour - Hour in 24-hour format. (Range: 0 - 23)
min - Minute. (Range: 0 - 59)
sec - Second. (Range: 0 - 59)
day - Day of month. (Range: 1 - 31)
month - january | february | march | april | may | june | july | august | september |
october | november | december
year - Year (4-digit). (Range: 1970 - 2037)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Note that when SNTP is enabled, the system clock cannot be manually configured.
Example
This example shows how to set the system clock to 15:12:34, February 1st, 2011.
Console#calendar set 15:12:34 1 February 2011
Console#
show calendar
This command displays the system clock.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Example
Console#show calendar
15:12:34 February 1 2011
Console#