Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1021)

Brocade 6910 Ethernet Access Switch Configuration Guide 965
53-1002651-02
43
Simple Network Management Protocol
FIGURE 266 Configuring Remote SNMPv3 Users
To show remote SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Remote User from the Action list.
FIGURE 267 Showing Remote SNMPv3 Users
Specifying Trap Managers
Use the Administration > SNMP (Configure Trap) page to specify the host devices to be sent traps
and the types of traps to send. Traps indicating status changes are issued by the switch to the
specified trap managers. You must specify trap managers so that key events are reported by this
switch to your management station (using network management software). You can specify up to
five management stations that will receive authentication failure messages and other trap
messages from the switch.
CLI References
• “snmp-server host” on page 111