Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 810)

754 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
35
IEEE 802.1Q VLANs
FIGURE 82 Modifying Settings for Static VLANs
To show the configuration settings for VLAN groups:
1. Click VLAN, Static.
2. Select Show from the Action list.
FIGURE 83 Showing Static VLANs
Adding Static Members to VLANs
Use the VLAN > Static page to configure port members for the selected VLAN index, interface, or a
range of interfaces. Use the menus for editing port members to configure the VLAN behavior for
specific interfaces, including the mode of operation (Hybrid or 1Q Trunk), the default VLAN
identifier (PVID), accepted frame types, and ingress filtering. Assign ports as tagged if they are
connected to 802.1Q VLAN compliant devices, or untagged they are not connected to any
VLAN-aware devices. Or configure a port as forbidden to prevent the switch from automatically
adding it to a VLAN via the GVRP protocol.
CLI References
• “Configuring VLAN Interfaces” on page 377
• “Displaying VLAN Information” on page 384
Parameters
These parameters are displayed:
Edit Member by VLAN
• VLAN – ID of configured VLAN (1-4093).
• Interface – Displays a list of ports or trunks.