Lldp notification, Show lldp config, Lldp notification show lldp config – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 566

Advertising
background image

510

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

24

LLDP Commands

lldp notification

This command enables the transmission of SNMP trap notifications about LLDP changes. Use the
no form to disable LLDP notifications.

Syntax

[no] lldp notification

Default Setting
Disabled

Command Mode
Interface Configuration (Ethernet, Port Channel)

Command Usage

•

This option sends out SNMP trap notifications to designated target stations at the interval
specified by the

lldp notification-interval

command. Trap notifications include information

about state changes in the LLDP MIB (IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1
and LLDP-EXT-DOT3 MIBs.

•

SNMP trap destinations are defined using the

snmp-server host

command.

•

Information about additional changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the time of a trap notification
are included in the transmission. An SNMP agent should therefore periodically check the value
of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange notification-events
missed due to throttling or transmission loss.

Example

Console(config)#interface ethernet 1/1

Console(config-if)#lldp notification

Console(config-if)#

show lldp config

This command shows LLDP configuration settings for all ports.

Syntax

show lldp config [detail interface]

detail - Shows configuration summary.

interface

ethernet unit/port

unit - Unit identifier. (Range: 1)

port - Port number. (Range: 1-12)

port-channel channel-id (Range: 1-12)

Command Mode
Privileged Exec

Advertising