Displaying results of remote loop back testing, Figure 332 dis – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 1102

Advertising
background image

1046

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

43

OAM Configuration

Displaying Results of Remote Loop Back Testing

Use the Administration > OAM > Remote Loop Back (Show Test Result) page to display the results
of remote loop back testing for each port for which this information is available.

CLI References

•

“show efm oam remote-loopback interface”

on page 577

Parameters
These parameters are displayed:

•

Port – Port identifier. (Range: 1-12)

•

Packets Transmitted – The number of loop back frames transmitted during the last loop back
test on this interface.

•

Packets Received – The number of loop back frames received during the last loop back test on
this interface.

•

Loss Rate – The percentage of packets transmitted for which there was no response.

Interface
To display the results of remote loop back testing for each port for which this information is
available:

1. Click Administration, OAM, Remote Loop Back.

2. Select Show Test Result from the Action list.

FIGURE 332

Displaying the Results of Remote Loop Back Testing

Advertising