Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 750)

694 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
33
Configuring Telnet Settings
Interface
To configure parameters for the console port:
1. Click System, then Console.
2. Specify the connection parameters as required.
3. Click Apply
FIGURE 24 Console Port Settings
Configuring Telnet Settings
Use the System > Telnet menu to configure parameters for accessing the CLI over a Telnet
connection. You can access the onboard configuration program over the network using Telnet (i.e.,
a virtual terminal). Management access via Telnet can be enabled/disabled and other parameters
set, including the TCP port number, time outs, and a password. Note that the password is only
configurable through the CLI.) These parameters can be configured via the web or CLI interface.
CLI References
• “Line” on page 75
• “Telnet Server” on page 162
Parameters
The following parameters are displayed:
• Telnet Status – Enables or disables Telnet access to the switch. (Default: Enabled)
• TCP Port – Sets the TCP port number for Telnet on the switch. (Default: 23)
• Max Sessions – Sets the maximum number of Telnet sessions that can simultaneously
connect to this system. (Range: 0-8)
A maximum of eight sessions can be concurrently opened for Telnet and Secure Shell (i.e.,
both Telnet and SSH share a maximum number or eight sessions).
• Login Timeout – Sets the interval that the system waits for a user to log into the CLI. If a login
attempt is not detected within the timeout interval, the connection is terminated for the
session. (Range: 10-300 seconds; Default: 300 seconds)