Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 565)

Brocade 6910 Ethernet Access Switch Configuration Guide 509
53-1002651-02
24
LLDP Commands
lldp dot3-tlv mac-phy
This command configures an LLDP-enabled port to advertise its MAC and physical layer
capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv mac-phy
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises MAC/PHY configuration/status which includes information about
auto-negotiation support/capabilities, and operational Multistation Access Unit (MAU) type.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv mac-phy
Console(config-if)#
lldp dot3-tlv max-frame
This command configures an LLDP-enabled port to advertise its maximum frame size. Use the no
form to disable this feature.
Syntax
[no] lldp dot3-tlv max-frame
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Refer to
“Frame Size” on page 65 for information on configuring the maximum frame size for this
switch.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv max-frame
Console(config-if)#