Showing acl hardware counters, Figure 217 s, Showing acl – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 956: Hardware counters
900
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
42
Access Control Lists
Showing ACL Hardware Counters
Use the Security > ACL > Configure Interface (Show Hardware Counters) page to show statistics for
ACL hardware counters.
CLI References
•
Parameters
These parameters are displayed:
•
Port – Port identifier. (Range: 1-12)
•
Type – Selects the type of ACL.
•
Direction – Selects ingress or egress traffic.
•
Query – Displays statistics for selected criteria.
•
ACL Name – The ACL bound this port.
•
Action – Shows if action is to permit or deny specified packets.
•
Rules – Shows the rules for the ACL bound to this port.
•
Time-Range – Name of a time range.
•
Hits – Shows the number of packets matching this ACL.
•
Clear Counter – Clears hit counter for rules in specified ACL.
Interface
To show statistics for ACL hardware counters:
1. Click Security, ACL.
2. Select Configure Interface from the Step list.
3. Select Show Hardware Counters from the Action list.
4. Select a port.
5. Select ingress or egress traffic.
FIGURE 217
Showing ACL Statistics