Performing loopback testing, Figure 51, Performing – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 778: Loopback testing, Loopback test

Advertising
background image

722

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

34

Port Configuration

Parameters
These parameters are displayed:

•

Port – Switch port identifier.

•

Type – Displays media type. (GE – Gigabit Ethernet, Other – SFP)

•

Link Status – Shows if the port link is up or down.

•

Test Result – The results include common cable failures, as well as the status and approximate
distance to a fault, or the approximate cable length if no fault is found.
To ensure more accurate measurement of the length to a fault, first disable power-saving
mode on the link partner before running cable diagnostics.

For link-down ports, the reported distance to a fault is accurate to within +/- 2 meters. For
link-up ports, the accuracy is +/- 10 meters.

•

Last Updated – Shows the last time this port was tested.

Interface
To test the cable attached to a port:

1. Click Interface, Port, Cable Test.

2. Click Test for any port to start the cable test.

FIGURE 51

Performing Cable Tests

Performing Loopback Testing

Use the Interface > Port > Ethernet Loopback pages to loop traffic back from the destination port
to the source port, display configuration settings and the system resources used by this function.

CLI References

•

“ethernet loopback”

on page 280

•

“show ethernet loopback interface”

on page 281

•

“show ethernet loopback resources”

on page 281

Advertising