Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1183)

Brocade 6910 Ethernet Access Switch Configuration Guide 1127
53-1002651-02
47
Multicast VLAN Registration for IPv6
FIGURE 402 Displaying MVR Statistics – Port
Multicast VLAN Registration for IPv6
MVR6 functions in a manner similar to that described for MRV (see “Multicast VLAN Registration
for IPv6” on page 1127).
Command Usage
• General Configuration Guidelines for MVR6:
1. Enable MVR6 for a domain on the switch, and select the MVR VLAN (see “Configuring
MVR6 Domain Settings” on page 1129).
2. Create an MVR6 profile by specifying the multicast groups that will stream traffic to
attached hosts, and assign the profile to an MVR6 domain (see “Configuring MVR6 Group
Address Profiles” on page 1130).
3. Set the interfaces that will join the MVR as source ports or receiver ports (see “Configuring
MVR6 Interface Status” on page 1133).
4. For multicast streams that will run for a long term and be associated with a stable set of
hosts, you can statically bind the multicast group to the participating interfaces (see
“Assigning Static MVR6 Multicast Groups to Interfaces” on page 1134).