Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 337)

Brocade 6910 Ethernet Access Switch Configuration Guide 281
53-1002651-02
12
Interface Commands
Example
Console(config)#interface ethernet 1/10
Console(config-if)#ethernet loopback vlan 1-2
Console(config-if)#
show ethernet loopback interface
This command shows adminstative status for each port, and the associated VLANs.
Syntax
show ethernet loopback interface [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show ethernet loopback interface
Loopback Information of Eth 1/1
Type : Port
Status : Enabled
Loopback Information of Eth 1/10
Type : VLAN
VLAN List : 1, 2
...
show ethernet loopback resources
This command shows the available resources, and those used by loopback testing.
Syntax
show ethernet loopback resources
Command Mode
Privileged Exec
Command Usage
This command displays the total number of loopback entries supported the by system, the number
of available entries, and the number of entries currently configured.
Example
Console#show ethernet loopback resources
Total Resources : 240
Free Resources : 236
Resources Used by Users : 4