Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 707)

Brocade 6910 Ethernet Access Switch Configuration Guide 651
53-1002651-02
31
Debug Commands
Group: 225.128.1.2, Source: 0.0.0.0, Upstream VLAN: 0, rp: 0
Flags: , SNP, , , , Hit Bit: 0
Snooping interface:
L2 interface: 1(Flags : CHIP,,,) port:1,
Multicast downstream interface:
MVR downstream interface:
Group: 233.171.129.255, Source: 0.0.0.0, Upstream VLAN: 0, rp: 0
Flags: , SNP, , , , Hit Bit: 0
Snooping interface:
L2 interface: 5(Flags : CHIP,,,) port:5,
Multicast downstream interface:
MVR downstream interface:
Group: 239.255.255.250, Source: 0.0.0.0, Upstream VLAN: 0, rp: 0
Flags: , SNP, , , , Hit Bit: 0
Snooping interface:
L2 interface: 1(Flags : CHIP,,,) port:1,
L2 interface: 5(Flags : CHIP,,,) port:5,
Multicast downstream interface:
MVR downstream interface:
Console#
debug erps
This command shows ERPS administrative configuration, operational status, and the status of
health PDUs.
Syntax
debug erps {adm | opr | healthpdu} [domain domain-name]
adm - Shows ERPS administrative status.
opr - Shows ERPS operational status.
healthpdu - Shows status of ERPS health PDUs.
domain - Shows information for the specified ERPS ring.
domain-name - Name of an ERPS ring. (Range: 1-12 characters)
Command Mode
Privileged Exec