Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 209)

Brocade 6910 Ethernet Access Switch Configuration Guide 153
53-1002651-02
9
AAA
aaa accounting exec
This command enables the accounting of requested Exec services for network access. Use the no
form to disable the accounting service.
Syntax
aaa accounting exec {default | method-name}
start-stop group {radius | tacacs+ |server-group}
no aaa accounting exec {default | method-name}
default - Specifies the default accounting method for service requests.
method-name - Specifies an accounting method for service requests. (Range: 1-64
characters)
start-stop - Records accounting from starting point and stopping point.
group - Specifies the server group to use.
radius - Specifies all RADIUS hosts configure with the radius-server host command.
tacacs+ - Specifies all TACACS+ hosts configure with the tacacs-server host command.
server-group - Specifies the name of a server group configured with the aaa group
server command. (Range: 1-64 characters)
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
• This command runs accounting for Exec service requests for the local console and Telnet
connections.
• Note that the default and method-name fields are only used to describe the accounting
method(s) configured on the specified RADIUS or TACACS+ servers, and do not actually send
any information to the servers about the methods to use.
Example
Console(config)#aaa accounting exec default start-stop group tacacs+
Console(config)#