Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1098)

1042 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
43
OAM Configuration
Displaying the OAM Event Log
Use the Administration > OAM > Event Log page to display link events for the selected port.
CLI References
• “show efm oam event-log interface” on page 576
Command Usage
• When a link event occurs, no matter whether the location is local or remote, this information is
entered in OAM event log.
• When the log system becomes full, older events are automatically deleted to make room for
new entries.
• The time of locally generated events can be accurately retrieved from the sysUpTime variable.
For remotely generated events, the time of an event is indicated by the reception of an Event
Notification OAMPDU from the peer.
Interface
To display link events for the selected port:
1. Click Administration, OAM, Event Log.
2. Select a port from the drop-down list.
FIGURE 329 Displaying the OAM Event Log